Ford Focus Front Wheel Bearing Torque Setting

Ford ranger wheel lug torque specifications for all years measure 100 foot pounds as do f150s with 12 mm studs which were produced from 1988 to 2000. Torque spec on front wheel bearing needed i just replaced my front wheel bearings on a 2002 focus zx5. The correct torque value according to the haynes repair manual for ford focus is 94 footpounds for 2001 and later models read more wheel bearing read more the ford focus header bolt torque specification is 90 pounds.

ford focus front wheel bearing torque setting

Motor Zetec

Harmonic Balancer Torque Specs Dorman Applications Torque Spec L

S40 06 Front Wheel Bearing Volvo Owners Club Forum

Along with new struts and sway bar linkages.

Ford focus front wheel bearing torque setting.

In the focus the bearing is press fitted into the steering knuckle and the wheel hub is press fitted into the inner race of the wheel bearing.
Ford focus transit connect front wheel bearing replacement.
Ford front wheel bearings do have a torque spec.
The procedure for replacing fwd pressed fitted steering knuckle bearings is basically the same for most cars with this configuration with minor differences.

Putting the proper torque on the center axle nut sets the preload for the bearing and keeps the bearing from separating while in operation.
Most drive axle wheel hubs have a center axle nut that must be torqued down onto the axle shaft to a specic torque value.
The header bolts should be torqued in 45 pound intervals.
I have no idea what that spec is though.

It is all over the new part to torque to mfr spec or damage will occur.
Whats the correct torque setting.
2001 ford focus black edition posted september 9 2010 ive found someone to lend me a torque wrench so all i need now is to find the torques settings for the rear hub nuts and rear wheels for a 2001 16 ford focus.
F150s produced from 2000 onward with 14 mm studs measure 150 foot pounds.

Due to the varying torque spec throughout the years on these two different models please leave a comment down below requesting the.
Posted on nov 07 2009.
Anyway i pre tightned them to about 180 but ive read two different specs 219 and 233 ftp.